Welcome to
Search

Main Menu
· Home
· Downloads

Knowledge Base
·Main
·Procedures & Solutions
·Errors and Troubleshooting
·Frequently Asked Questions

  



[ Downloads Main | Add Download | New | Popular | Top Rated ]

Category: Main/ Digital Wrench Version 4.3 Updates


Sort Downloads by: Title (A\D) Date (A\D) Rating (A\D) Popularity (A\D)
Resources currently sorted by: Title (A to Z)


  Digital Wrench Version 4.3 Update 09/29/2021 
Description: This update consists of all changes to Digital Wrench Version 4.3 since the original version was released in August 2021.

IMPORTANT:

-Digital Wrench software is supported ONLY ON Windows 8 or Windows 10.
-Digital Wrench WILL NOT FUNCTION CORRECTLY ON Windows XP. or Windows 7.
-Digital Wrench WILL NOT INSTALL on Windows Versions older than Windows XP.

THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 4.3 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.

FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 4.3 INSTALLER. Communication with the Indian Challenger, FTR and 2022 Chief Motorcycles is only possible using the MultiLink XP Interface Module.
SmartLink Modules will not function on these vehicles.

Update 09/29/21 Includes the following changes & additions from the original program release and Previous Updates:

-Addition of 2022 600 and 800 Snow Models.
-Revised EPS Calibration for certain 2021 ATV Models.
-Revised Calibrations for 2019-2021 Indian China Models.
-Additional 2020 FTR 1200 Models.
-Additional 2021 Ranger 150 Models.
-Additional 2021 RZR Models.
-Revised Speedometer Calibration for 2021 Indian Models.

IMPORTANT: This update mayalso perform a firmware update on either the SmartLink or MultiLink XP Interface Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink or MultiLink XP.

NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.

Click the link above, save the file to your hard disk and then double-click the icon to start the update process.

When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 4.3 09/29/2021".

Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.


Version: 43_092921 Filesize: 51.38 MB
Added on: 29-Sep-2021 Downloads: 2244
HomePage | Rate Resource | Details

  
Who's Online
There are currently, 30 guest(s) and 0 member(s) that are online.

You are Anonymous user. You can register for free by clicking here

All logos and trademarks in this site are property of their respective owner. The comments are property of their posters, all the rest � 2003-2004 by Diagnostic Systems Associates, Inc.
Web site engine's code is Copyright © 2003 by PHP-Nuke. All Rights Reserved. PHP-Nuke is Free Software released under the GNU/GPL license.
Page Generation: 0.205 Seconds