Category: Main/Digital Wrench 4.2 Updates|
Sort Downloads by: Title (A\D) Date (A\D) Rating (A\D) Popularity (A\D)
Resources currently sorted by: Title (A to Z)
| Digital Wrench Version 4.2 Update 09/09/2020 |
This update consists of all changes to Digital Wrench Version 4.2 since the original version was released in August 2020.
-Digital Wrench software is supported ONLY ON Windows 8 or Windows 10.
-Digital Wrench WILL NOT FUNCTION CORRECTLY ON Windows XP. or Windows 7.
-Digital Wrench WILL NOT INSTALL on Windows Versions older than Windows XP.
THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 4.2 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.
FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 4.2 INSTALLER.
Communication with the Indian Challenger and FTR 1200 Motorcycle is only possible using the MultiLink XP Interface Module.
SmartLink Modules will not function on these vehicles.
Update 09/09/20 Includes the following changes & additions from the original program release and Previous Updates:
-Addition of Model Year 2021 Matryx Snow Models
-Addition of Model Year 2021 GEM Models
-Addition of Model Year 2021 Sportsman Twin Models
-Addition of Model Year 2019 Sportsman Single Models
-Addition of revised calibrations for 2016-2019 GEM BMC Modules
-Addition of Stage calibrations for 2020 Indian Motorcycles
IMPORTANT: This update may also perform a firmware update on either the SmartLink or MultiLink XP Interface Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink or MultiLink XP.
NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.
Click the link above, save the file to your hard disk and then double-click the icon to start the update process.
When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 4.2 09/09/2020".
Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.
Version: 42_090920 Filesize: 59.62 MB
Added on: 10-Sep-2020 Downloads: 988
HomePage | Rate Resource | Details
|There are currently, 29 guest(s) and 0 member(s) that are online.|
You are Anonymous user. You can register for free by clicking here