Category: Main/Digital Wrench 4.0 Updates|
Sort Downloads by: Title (A\D) Date (A\D) Rating (A\D) Popularity (A\D)
Resources currently sorted by: Title (A to Z)
| Digital Wrench Version 4.0 Update 02/28/2019 |
This update consists of all changes to Digital Wrench Version 4.0 since the original version was released in August 2018.
THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 4.0 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.
FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 4.0 INSTALLER.
Update 02/28/19 Includes the following changes & additions from the original program release and Previous Updates:
-Revised calibration for 2018-19 RANGER XP NorthStar Vehicles
-Revised calibration for GEM Battery Controller Module
-Addition of 2019 ATV 850 and 1000 Vehicles
-Addition of 2019 International ATV 570 Models
IMPORTANT: This update may also perform a firmware update on the SmartLink Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink.
NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.
Click the link above, save the file to your hard disk and then double-click the icon to start the update process.
When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 4.0 02/28/2019".
Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.
Version: 40_022819 Filesize: 48.67 MB
Added on: 01-Mar-2019 Downloads: 1707
HomePage | Rate Resource | Details
|There are currently, 31 guest(s) and 0 member(s) that are online.|
You are Anonymous user. You can register for free by clicking here