Category: Main/Digital Wrench Version 3.9 Updates|
Sort Downloads by: Title (A\D) Date (A\D) Rating (A\D) Popularity (A\D)
Resources currently sorted by: Rating (Lowest Scores to Highest Scores)
| Digital Wrench Version 3.9 Update 03/02/18 |
This update consists of all changes to Digital Wrench Version 3.9 since the original version was released in August 2017.
THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 3.9 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.
FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 3.9 INSTALLER.
Update 02/18/18 Includes the following changes & additions from the original program release and Previous Updates:
-Updated Battery Controller Calibrations for GEM Vehicles.
-Addition of 2018 Ranger 150
-Addition of 2019 Axys 800 Early Build Snowmobiles
IMPORTANT: This update may also perform a firmware update on the SmartLink Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink.
NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.
Click the link above, save the file to your hard disk and then double-click the icon to start the update process.
When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 3.9 03/02/18".
Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.
Version: 39_030218 Filesize: 99.23 MB
Added on: 05-Mar-2018 Downloads: 1649
HomePage | Rate Resource | Details
|There are currently, 10 guest(s) and 0 member(s) that are online.|
You are Anonymous user. You can register for free by clicking here