Procedures & Solutions
Errors and Troubleshooting
Frequently Asked Questions
Request Download Modification
This update consists of all changes to Digital Wrench Version 4.1 since the original version was released in September 2019.
-Digital Wrench software is supported ONLY ON Windows 7 (SP1), Windows 8 or Windows 10.
-Digital Wrench WILL NOT FUNCTION CORRECTLY ON Windows XP.
-Digital Wrench WILL NOT INSTALL on Windows Versions older than Windows XP.
THIS UPDATE WILL NOT INSTALL ON OLDER VERSIONS OF DIGITAL WRENCH. YOU MUST ALREADY HAVE VERSION 4.1 INSTALLED ON YOUR PC BEFORE ATTEMPTING TO INSTALL THIS UPDATE.
FOLLOW THE APPROPRIATE LINKS ON THE DEALER EXTRANET OR CONTACT POLARIS TECHNICAL SUPPORT IF YOU NEED INFORMATION ON HOW TO OBTAIN THE DIGITAL WRENCH VERSION 4.0 INSTALLER. Communication with the Indian Challenger and FTR 1200 Motorcycle is only possible using the MultiLink XP Interface Module.
SmartLink Modules will not function on these vehicles.
Update 05/07/20 Includes the following changes & additions from the original program release and Previous Updates:
-Addition of revised VCM Calibration for Indian Motorcycles missing from the previous update
-Addition of 2020 Slingshot Manual Transmission Models
-Addition of 2020 International RZR Models
-Addition of 2020 Mid-Year RZR Turbo Models
-Addition of 2021 Ranger 570 International Models
-Revised Calibrations for 2019 RANGER and RZR XP 1000 Vehicles
IMPORTANT: This update may also perform a firmware update on either the SmartLink or MultiLink XP Interface Module the first time it is connected. This update procedure must be allowed to complete before using the SmartLink or MultiLink XP.
NOTE: Reflashing a calibration should only be performed while working on a related issue, replacing an ECU or if there is an outstanding Service Bulletin requiring the ECU to be reflashed.
Click the link above, save the file to your hard disk and then double-click the icon to start the update process.
When the update is complete, the Version shown on the right side of the Digital Wrench Start-up Screen should read "Version 4.1 05/07/2020".
Note: Do not "run" or "open" the file from where they are. Select "save" and download them to your PC before running the install.
_Archive/Digital Wrench 4.0 Updates Archive
_Archive/Digital Wrench 4.1 Updates Archive
Digital Wrench 4.2 Updates
_Archive/Digital Wrench 4.2 Updates Archive
_Archive/Digital Wrench Version 3.9 Updates Archive
USB Adapter Drivers
Filesize: (in bytes)
There are currently, 28 guest(s) and 0 member(s) that are online.
You are Anonymous user. You can register for free by clicking
All logos and trademarks in this site are property of their respective owner. The comments are property of their posters, all the rest � 2003-2004 by Diagnostic Systems Associates, Inc.
Web site engine's code is Copyright © 2003 by
. All Rights Reserved. PHP-Nuke is Free Software released under the
Page Generation: 0.214 Seconds