Polaris Digital Wrench
Polaris Digital Wrench
On-line Help System
Glossary    Contact Us
Search  
   
Browse by Category
Polaris Digital Wrench .: Procedures & Solutions .: Checking for Power in the Diagnostic Connector

Checking for Power in the Diagnostic Connector

Version: All
Operating System(s): All

Description: If there is no power, or ground to the vehicle Diagnostic Connector, the Digital Wrench will not function. The Communications Status will always display "No Cable, or Power".

Procedure: To check for power to the Diagnostic Connector, refer to the following diagram.

With the ignition key on make sure there is at least 11 Volts between the Battery + and Ground Terminals of the Diagnostic Connector.

Also, many vehicles require that a "Bypass Jumper", or other test device be installed before power will be available at the diagnostic connector. Always refer to the manufacturers diagnostic procedures for the vehicle being tested.



How helpful was this article to you?

Related Articles

article Status "No Cable or Power"
Commstatus Always Displays "No Cable, or Power"Version: AllOperating System(s): All

  8-13-2004    Views: 5010   

User Comments

Add Comment
No comments have been posted.


.: Powered by Lore 1.4.3
[ Admin Login ]
Copyright 2004 Diagnostic Systems Associates Inc.